Don't know if it is a bug or I'm just missing something, but after setting up the first bus line in the tutorial I bought 4 vehicles to operate it. The first bus left the Depot and startet ist tour. Then I edited the time table and increased the Intervalls by 30 minutes, just because it was suggested by the tutorial. The first bus completed ist tour, returned to the Depot and since then no bus left it. All 4 are just Standing there, doing nothing and I can't find a way to force them out.
-
We have updated our Community Code of Conduct. Please read through the new rules for the forum that are an integral part of Paradox Interactive’s User Agreement.
Look at the timetable and the time of departure according to the current day (bottom left corner). Wait for the next departure time and it there is really no buses going out, then you might have a bug...
Could also be that you closed the line (red/green dot in the line window).
Zarine's advice is good. You could also check what day it is the game, the weekend timetables are different and the vehicles drive less often then. If the problem still persists, it is a bug, but so far there have been no reports on this kind of behavior.
I set the TT to 7 days a week and it was the middle of the day. interestingly after selling the busses and buying new one without editing the TT they went out as it should be 
Good to know you got it to work! I'll mark this down as a bug and keep my eyes open if I see it again.
I have noticed this with a tram line I created too. I had 8 trams and changed the timetable to despatch 1 per hour, instead of 1 each 2 hours and the trams would not leave the depot. I then changed the timetable back to 1 each 2 hours and they started leaving the depot again.
To fix, I had to do what Avatar2312 did above. After I change the timetable, I have to sell all the trams in the depot and buy them again. Now they will leave 1 per hour as per the timetable.
Thanks
Mark
To fix, I had to do what Avatar2312 did above. After I change the timetable, I have to sell all the trams in the depot and buy them again. Now they will leave 1 per hour as per the timetable.
Thanks
Mark
Possibly somewhat related: when I built my first in-game bus line, I made it start at Depot 1 and end at Depot 2. However, my 3 buses never left the first Depot. (I haven't had time yet to see if this would happen if I started and ended a bus line at the same Depot.) Am I doing something wrong or is this a bug?
Hi All,
I purchased the game today on Steam and I have the same problem during the tutorial and also on the next campaign map.
Bus depot and line is created, the line is enabled, the depot is full with vehicles, but they are not assigned to the line.
I have tried to change the line schedule, sold all buses and bought new ones, but nothing helps. It does not seem I'm missing anything obvious, so I think this is a bug.
I purchased the game today on Steam and I have the same problem during the tutorial and also on the next campaign map.
Bus depot and line is created, the line is enabled, the depot is full with vehicles, but they are not assigned to the line.
I have tried to change the line schedule, sold all buses and bought new ones, but nothing helps. It does not seem I'm missing anything obvious, so I think this is a bug.
The line has to start and end at the same depot. They will not leave until it's closed this way.
Note that you can tell your line to go round by doing Depot -> stop 1 -> stop 2 -> stop 1 -> depot. Bus would drive until maintenance is low and then head back to depot.
I've also had this problem. My first bus line on the map, and the buses refused to leave the depot. I had to sell the vehicles and buy them again to make it work.
Same in one of my water bus line. I just delete the line and set up again, it works!
Definitely I have the same bug. It happens randomly when I edit the timetable. Often if I close the line and then re-open it the vehicles start to flow, but sometimes I must sell all the vehicles and then buy them again.